Chip tuning 2019. Alexey Pakhomov
Content: пароль dedmun.txt (140 B)
Available: 1
Uploaded: 11.11.2019
Positive responses: 0
Negative responses: 0
Sold: 0
Refunds: 0
$4.85
If you don’t know what chip tuning is, what equipment is needed for this, what is inside the electronic engine control unit, how to “sew” it, how to edit calibration, then the “Chip tuning 2019” video course is what you need ! 30 lessons.
Lesson 1. Introduction
Lesson 2. The internal structure of the computer. Part one
Lesson 3. The internal structure of the computer. Part two
Lesson 4. Firmware structure
Lesson 5. Communication Buses
Lesson 6. The process of performing chip tuning. Reprogramming the computer
Lesson 7. VAZ control units
Lesson 8. Installing and configuring the CombiLoader bootloader. Program interface
Lesson 9. Programming an ECU with a C509 processor
Lesson 10. Programming the BOSCH 7.9.7 ECU
Lesson 11. Computer programming with ST10 and C16x processors
Lesson 12. Installing a key and additional modules
Lesson 13. Programming CAN Control Units
Lesson 14. Programming blocks M74
Lesson 15. Programming M86 blocks
Lesson 16. Cummins Block Programming
Lesson 17. Programming BOSCH MEG blocks 17.9.12
Lesson 18. Programming the EDC17CP54 Unit
Lesson 19. ChipTuningPro program interface. Calibration Types
Lesson 20. Editing three-dimensional surfaces
Lesson 21. Editing the error mask and firmware identifier. Configuration flags
Lesson 22. Creating a dual-mode firmware
Lesson 23. Additional Features of ChipTuningPro
Lesson 24. Recalibration and Security
Lesson 25. Idle and for
Lesson 2. The internal structure of the computer. Part one
Lesson 3. The internal structure of the computer. Part two
Lesson 4. Firmware structure
Lesson 5. Communication Buses
Lesson 6. The process of performing chip tuning. Reprogramming the computer
Lesson 7. VAZ control units
Lesson 8. Installing and configuring the CombiLoader bootloader. Program interface
Lesson 9. Programming an ECU with a C509 processor
Lesson 10. Programming the BOSCH 7.9.7 ECU
Lesson 11. Computer programming with ST10 and C16x processors
Lesson 12. Installing a key and additional modules
Lesson 13. Programming CAN Control Units
Lesson 14. Programming blocks M74
Lesson 15. Programming M86 blocks
Lesson 16. Cummins Block Programming
Lesson 17. Programming BOSCH MEG blocks 17.9.12
Lesson 18. Programming the EDC17CP54 Unit
Lesson 19. ChipTuningPro program interface. Calibration Types
Lesson 20. Editing three-dimensional surfaces
Lesson 21. Editing the error mask and firmware identifier. Configuration flags
Lesson 22. Creating a dual-mode firmware
Lesson 23. Additional Features of ChipTuningPro
Lesson 24. Recalibration and Security
Lesson 25. Idle and for
No feedback yet